Last Modified: 11-29-2007 1.6 A
Service Category: Brake Section: Brake Control/Dynamic Control System
Model Year: 2008 Model: Sequoia Doc ID: RM000001B2E00BX
Title: BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR: INSTALLATION (2008 Sequoia)

INSTALLATION

1. INSTALL REAR SPEED SENSOR LH



(a) Using a hexagon wrench, install the rear speed sensor with the bolt.

Torque: 8.3 N·m (85 kgf·cm, 73 in·lbf)

NOTICE:

  • Make sure that there are no pieces of iron or other foreign matter attached to the sensor tip part.
  • While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip part.
  • After installing the speed sensor, make sure that there is no clearance or foreign matter between the sensor stay part and the knuckle.
  • Make sure that there is no foreign matter attached to the magnetic rotor.

(b) Connect the rear speed sensor connector.

2. INSTALL REAR WHEEL REAR SUSPENSION: REAR SHOCK ABSORBER: INSTALLATION (2008 Sequoia)+

3. INSPECT SPEED SENSOR SIGNAL

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: TEST MODE PROCEDURE (2008 Sequoia)